The antecedents of lens scratches, quick to understand!

Lens scratches have always been a common problem in plastic mirror review. Today, we will explain the antecedents and consequences of scratches in detail.

1, the cause of scratches
In the daily care of lenses, the lens scrubbing is not standard enough, which is an important cause of scratches.

2, Several major symptoms of serious wear and tear
1. Strong foreign body sensation after wearing the lens, no relief or aggravation of symptoms after eye closure for more than 10 minutes (no improvement after re-cleaning the lens and wearing it);
2. The foreign body sensation after wearing the lens did not improve after removing the protein;
3. In the morning after wearing the lens, the eyes often have more secretions or even inflammation without any reason;
4. In the case of wearing glasses normally, the naked eye vision in the daytime for several days is obviously decreased

微信图片_20210130163957

3, How to deal with wear and tear
Regular review is a good way to avoid serious wear and tear, when it is not serious, can be polished to restore the condition of the lens.
However, there is one caveat! Polishing grinding is bound to affect the design of the lens, so wear often probability has influence on the wearing effect after (such as shaping effect, comfortable degree and vision during the day, etc.), so it is a necessity to practice, were it not for the lens and cornea of the fit status also needs to be modified, otherwise, and not as a universal method of repair! And when the wear is very serious, the above 4 kinds of conditions, often even polishing and polishing can not save the lens, can only stop wearing change processing, so be sure to wear the mirror review on time!

4, How to prevent it
The prevention method is mainly in the cleaning step, keep hands soft and clean, nails short and smooth, finger abdomen and palm without dead skin and calluses. Rub with soft finger abdomen when washing. When storing the lens, if you find the lens stuck vertically on the edge of the lens box, you can tilt the lens box and gently shake the lens box, so that the flowing nursing solution in the box will drive the lens until the lens sinks into the lens box. If this doesn't work, try putting a few drops of the solution on the concave side of the lens and repeating the previous steps will be easier. By all means, do not use your finger to "poke" the lens down, this operation is too evil! Pick the mirror, must spread a clean towel on the table, to prevent it from falling directly to the ground, the table top. When the lens falls on the floor or table, if the concave side is up, we should wet our finger with water or nursing solution, and then gently dip our finger into the lens. If the convex side is up, gently suck directly with the suction rod.


Post time: Aug-19-2022